Designed by
derek_kirkendall
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryHere's an enclosure I whipped up to house the Pololu Maestro Servo Control Board called out in the EEZYbotARM instructable. I made the walls thin as to not interfere with the mechanics. I also included a couple of spacers if the screws on hand don't fit the depth of the enclosure. With the spacers, up to a 7mm screw can be used. I wound up repurposing the servo control horn screws that were left over. The enclosure pictured is friction welded at the 3 points of contact with the base support (2 corner bottom, and top center). Enjoy!
Design Files
File Size
Maestro_Enclosure.stl
513 KB
Maestro_Lid.stl
14.1 KB
Comments