Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Show the world your devotion to Batman and Superman with this iPhone 6 case!
I printed this (with PLA) with these settings:
Speed: 40 mm/sec
Infill: 20%, honeycomb pattern
Layers: 0.3 mm each, 0.4 mm for first
Bridging or supports: None!
Filament settings will vary by filament. I use Inland's red PLA filament and MelkInk's gold PHA. Here are the settings I used:
Inland's red PLA:
Temperature: 220 C
Bed temperature: 57 C
MeltInk's gold PHA:
Temperature: 245 C
Bed temperature: 60 C
***Every 3D printer is different (and also material), so printing this out the first time may not fit your phone perfectly. Just rescale to 99% if it is too big, or 101% if it is too small. If the size is still off, rescale by 1% each time.
Comments