Designed by
ICanMakingThings
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryPrinting this now. I'll post pics if it turns out... or not. So far it's looking good.Post-PrintingRan a little tightI like the print, but it is a little tight. It was just barely too tight though. I cracked the bottom (smaller) side of the case when I was fitting it. I recommend trimming more of that material back or building slightly scaled up. So close.It was about a mm thinner than the phone, so I'll move that out.I'm also going to enlarge the "Seattle" so that prints better. I may enlarge the logo as well.
Design Files
File Size
Seahawks_Case_V1.stl
5.75 MB
Comments