XYZ DA VINCI DOUBLE FAN CARRIAGE.

Prints (0)

Description

Summary I'm developing this system for my Da Vinci 1.0 Open printer. . This new hotend has a 19mm. teflon barrel and a heat sink that I made on zamak spincasting. This is complemented by a brass nozzle. With this new system, the plastic filament is kept cold until it reaches the nozzle tip. It stays super cold. Im very happy. The carriage has a double fan. The front is to cool the heat sink. and the back, is to cool the filament coming out of the nozzle when printing Through a duct located inside the carriage. This version is for 15mm linear bearings. But it will also be available a version for mounting on original bushings. UPDATE 11 may 15 Some improvements in the design of direct drive / file now included. Some improvements in the design of the carriage and mounting system. Update 15/may/15 Carriage replacing the original file. changes in the fastening system and overall desing. Direct drive bracket. file replacement. adjustments to the fastening system and overall desing.

Design Files

File Size

UNION_BRACKET.stl
2.66 MB
TEFLON_BARREL.stl
4.71 MB
ALL.stl
82.7 MB
DIRECT_DRIVE_BRACKET.stl
7.44 MB
HOT_SINK.stl
8.92 MB
DIRECT_DRIVE_TENSION_ARM.stl
55.6 KB
CARRIAGE.stl
14.2 MB
BEARING_SPACERS.stl
200 KB
BAND_GRIPS.stl
3.07 MB
TOP_BOTTOM_BRACKETS.stl
6.42 MB
NOZZLE.stl
4.39 MB
HEATER.stl
2.82 MB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×