Internal PC Hotswap Case for standard CD-Rom place

Prints (0)

Description

This is design of hot swap for full size 3.5 inch with 2.5 inch tray HDD for internal pc cd-rom slot (FOR STANDARD CD-ROM PLACE).

Fits my pc case - may be different with other cases but should be similar i think. There are three packages STL, 3MF, and photo files . 3D packages have 14 files without photos. The photos show how it is supposed to be put together and what it can do. Besides, there is a video on YOUTUBE where I show how to assemble the case and how not to assemble it (I think I made all the mistakes I wanted to avoid, but it was my first video on YOUTUBE :) ).

I received sata cable connectors bent in all directions (in a place covered with hard rubber - shown in photo - inaccurate cast), so I decided to design and replace it.

If you have questions, leave a comment.

FIRST TWO WAS PRINTED WITHOUT KLIPPER ON E5 PRO with merli 2.0.6 AND THEY ARE SITTING IN MY PC :)

Printing time (all parts) was about 20-24 hours (That was tests-I can't say exactly)

All Files are exported in position that they were printed, the choice of adhesive layer is yours ).

There is need to have 7 skrews 3.5x9.5~9mm shown in the video.

Ender 5 Pro on klipper  (to get better quality I switched to KLIPPER, that is one that was assembling on video) speed - 80mm/s nozzle 0.4mm Pressure advance - setup on klipper (each printer is different need to be tested) acceleration - stock (500mm/s2)

SATA CONNECTOR PIN 2x.stl must be printed twice !!!

Files printed with 100% infill: CONNECTOR PLATE.stl FRONT CASE.stl FRONT FLAP PIN.stl FRONT FLAP.stl FRONT FLAP-PUSHER PIN.stl LONG PUSHER.stl PUSHERS CONNECTION PIN.stl SATA CONNECTOR BOTTOM.stl SATA CONNECTOR PIN 2x.stl         -        PRINT TWICE!!! SATA CONNECTOR TOP.stl SHORT PUSHER PIN.stl SHORT PUSHER.stl

Files printed with 15% infill: CASE.stl tray 2,5 inch.stl

SUPPORTS: CASE.stl tray 2,5 inch.stl FRONT FLAP.stl That was printed with supports or better to say they had supports in selected places.

Design Files

File Size

tray 2,5 inch.stl
1.1 MB
SHORT PUSHER.stl
1.04 MB
SHORT PUSHER PIN.stl
497 KB
SATA CONNECTOR TOP.stl
182 KB
SATA CONNECTOR PIN 2x.stl
180 KB
SATA CONNECTOR BOTTOM.stl
182 KB
PUSHERS CONNECTION PIN.stl
665 KB
LONG PUSHER.stl
508 KB
FRONT FLAP-PUSHER PIN.stl
583 KB
FRONT FLAP.stl
2.14 MB
FRONT FLAP PIN.stl
386 KB
FRONT CASE.stl
1020 KB
CONNECTOR PLATE.stl
760 KB
CASE.stl
3.21 MB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×