Earring Pendant with Swarovski Crystal

This design is an eye catching addition to a pair of hoop earrings. This is for you if you'd like to add some flavor to your daily routine. You might want to add these pendants to your hoops for after work drinks? Or on the weekends for a date with your friends? 

I've printed these earrings on the Form 2 and 3 in Clear Resin at 100 and 50 microns directly on the build platform. Just be careful when taking them off the build plate so you won't break them.  Alternatively, you can always print them with supports. You just have to sand them down later. UV cure only for a short time so your resin won't turn yellowish. 

Add the Swarovski Crystal "Tilted Chaton 4928" with two component glue specific for these type of gems. 

The hoops I've used have a pipe diameter of 4.15mm. 

Good luck! I'm excited to see your prints.