12 HOLDERS IN 1 STORAGE CUBE FOR NINTENDO SWITCH GAME CARTRIDGES

Here's an amazing little cube that will surprise you. Amazing because it fits in your hand (5.1 cm) and holds 12 cartridges. It will surprise you because when you open it, you can see all your cartridges at a glance. You don't have to pull out each cartridge until you find the right one. It will surprise you because you can insert and remove your cartridges without any effort and without any click. Your cartridges are perfectly held and will not be damaged during handling. Finally, its appearance is unique. You can display it proudly next to your console, no need to put it in a drawer. There are 3 models available. A flat, basic one, one with 3D decoration, a bi-color with relief, much more attractive.

Assembly guide here :

You will find all the instructions in Guide-en.pdf.

IMPORTANT: The files you purchase are sold under Copyright. This means that they cannot be sold or distributed for free. Additionally, you cannot sell prints made from these files. If you did, you would jeopardize the creation of new designs. Thank you for your understanding.

Printing settings :

Layer height: 0.2 mm (it is certainly possible to make thinner)

Material: PLA (tested), PETG (tested), ABS (probably possible, not tested). DON'T TRY WITH RESIN, IT WON'T WORK. Printing time: 9h30 - 10h00 Length: 21.5 m Weight: 64 g

link slot.stl must be printed with support (only in contact with the plate). Do not use any support for other parts. The parts are already in the correct orientation, do not change it in your "slicer".

For the temperatures and printing speeds, you can use the parameters that you master, depending on your printer and your filament.

This object is articulated and requires a high level of precision. Adherence to the build plate is therefore essential. The slightest deformation due to warping would compromise the correct opening and closing of the box. I advise you to use glue or lacquer to improve the adherence.