Traxxas Rustler Wing

Spoiler/wing to bolt onto the back of a Traxxas Rustler body. Just a quick design after ripping an old rear wing off. The picture is of V2.

It does require different screws from the stock ones though. I had some 1/2 inch #8 machine screws laying around that I used on it. 

V1 was my first attempt, but eye balling the angle at the back of the body was a bit off so it seems to lean back a bit. 

V2 corrects the issue of the angle being bad. As well as better countersinks for screws.  Not real sure when it is flipped in the STL compared to V1, but I flipped it 180 degrees and printed it flat there on its back.