Drill Press Base Compound Vice Mount

A unique solution for utilising your drill press to its full potential, this design allows your compound vice to mount perfectly on the base of your drill press.

You will need:

• A compound vice as in the pictures (this model is 105mm/4.25")
• 4x M12 x 50mm bolts
• 4x M12 Bolts
• 4x M12 washers
• 4x 7Gx25mm countersunk screws

Notes

*You need to print 2 lots of these files (one for each side)

*Suited for drill press slots spaced 98-100mm apart from each other.

*Some compound vices of this design have varied size tops but usually share the same base.

Recommended Print Settings

These settings are tested and printed with Cura V4.3 and Creality Ender 3.

1.75mm PLA filament

200 degrees C Extruder Temp

50-60 degrees C Bed Temp

Scale : 100%

~6hrs print time (depending on your bed adhesion settings)

Raft ( if desired) 8mm margin

Infill : 50%

Layer height : 0.2mm

perimeters : 7

Speed : 50mm/s