Dino-Hunt - 3D Printed by Dany Sanchez
2349
Printer Used
My Rating
My Thoughts
FANTASTIC PRINT! I designed this more than 2 years ago, before owning a 3D printer so I never knew if it would actually work, IT DOES! Each piece prints in about an hour, except for the tail, which is less than an hour. Support is needed since parts are complex and they don't sit flat on the build plate. Removing the support is not difficult (I recommend solluble though). Assembly is easy between parts.
Settings
Print Time
4
hr(s)
Material Type
ABS
Layer Height
0.35
mm
Print Speed
60.0
mm/s
Extrusion Temperature
230.0
°C
Infill %
15.0
%
Supports
Yes
Comments