Steampunk Lady : Zorana - 3D Printed by fantasygraph
1605
Printer Used
My Rating
My Thoughts
i was out of my usual ABS, so i used PET+ filament. i think it's a good filament for 'mechanical' part, but i didn't like the surface result compared to ABS. By the way, easy print in the original scale. I think that some parts (nose, back of the hair, ears..) if you print it bigger without support.. no problem if you scale down to 70 % .. (half of print time..)
Settings
Print Time
6
hr(s)
Material Brand
madesolid
Material Type
PET+
Layer Height
0.15
mm
Print Speed
60.0
mm/s
Extrusion Temperature
215.0
°C
Infill %
10.0
%
Comments