Fully assembled 3D printable wrench - 3D Printed by richard_swika

This print in PET+ was amazing. Out of all of these wrenches I've printed, this one came out the best; I never once had the support practically fall out and have the wrench work immediately. It was always a challenge and most of the time I couldn't get them to work well. It was also the first wrench ever, that printed with zero warping. Even with PLA I would get a little warping. Now I am really liking the Madesolid PET+ filament. After my first print I thought it wasn't any good. Lots of stringing and sticking to the nozzle. After a few adjustment it's printing as good or better than anything else, and is super strong. It's also really slippery, good for moving joints. Note I only used a temp of 235 C, not the 250 C it says on the label. Support was already in the model, not done by slicer. The other settings were: 1.7mm retraction, 70 % speed for the outlines, 60 bed temp, First layer speed 25%.