Bamboo Pot

Faux stained glass. Frame prints upright, "glass" pieces print upside down. Flip "glass" pieces over after printing and insert into upright frame. Pic of model shown was printed using only 2 layers for glass, but I prefer to use honeycomb infill on the glass. I print glass using 2 perimeters, 0 top, 2 bottoms, and 20 percent homeycomb infill. If you print glass solid, it will not allow enough light to show through the finished model. Glass in this model prints at 5 layers at .3mm. Glass is flipped over after printing to have the smooth, flat side showing on the outside, although, model can be viewed from either side.