Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
This is work in progress!
------------------------------
This is a carriage for the Hemera from E3D, designed with the intent to work without changes of the firmware.
Which is not yet the case, you have to adapt maximum Z height (+11) and X-(-4) and y-(-4) offset.
I have very limited time for this, Thats why I provide it in the hope that some one of the communitiy finalizes the Thing. And add Air flow and filament sensor to it.
Print Settings
Supports: Yes
Resolution: 0.2
Filament_material: PETG
Notes:
The inner sides of both halfs are best printed laying flat up. As in the 3mf file. Otherwise there is the risk that the belt looses his grip. You should use support blocker shown (red blocks) in the slicer.
Comments