No Prints Yet
Be the first to upload a Print for this Design!
I designed this 3D printable geometric lightning bolt in Fusion360.
It's a cool model to gift someone, or to use as a mold for epoxy resin as I do quite often :)
If you would like to use it as a resin mold. I would recommend scaling up the Z axis to a minimum of 2mm.
Afterwards, you should put some tape on the back of the print to prevent the resin from leaking out.
Now you are ready to fill it up with resin.
And there you go, you are now a resin artist ;)
3D printing settings
I printed it at 0.2mm layer height, 0.3mm layer width, 2 wall lines, 100% infill. Print speed of 45 - 50mm/sec will be fine.
It took me 1.75 hours to print it (dimensions 13 x 17 x 0.2cm).
You could print it faster if you reduce the infill or scale it down a bit.
It's all up to you.