Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
PayPal Donations :https://www.paypal.me/01044488692
pla ,infill 30%
ARDUINO SOURCE CODE
=================================================================================
/* Stepper Motor Control - one revolution
This program drives a unipolar or bipolar stepper motor. The motor is attached to digital pins 8 - 11 of the Arduino.
The motor should revolve one revolution in one direction, then one revolution in the other direction.
Created 11 Mar. 2007 Modified 30 Nov. 2009 by Tom Igoe
*/
#include
const int stepsPerRevolution = 360; // change this to fit the number of steps per revolution // for your motor
// initialize the stepper library on pins 8 through 11: Stepper myStepper(stepsPerRevolution, 6,7,12,13);
void setup() { // set the speed at 60 rpm: myStepper.setSpeed(3); // initialize the serial port: Serial.begin(9600); }
void loop() { Serial.println("counterclockwise"); myStepper.step(-stepsPerRevolution); digitalWrite (6,LOW) ; digitalWrite (7,LOW) ; digitalWrite (12,LOW) ; digitalWrite (13,LOW) ; delay(1000); Serial.println("clockwise"); myStepper.step(stepsPerRevolution); digitalWrite (6,LOW) ; digitalWrite (7,LOW) ; digitalWrite (12,LOW) ; digitalWrite (13,LOW) ; delay(1000);
}
Comments