Water Jet Drive 64 mm Version 2

Update 30.04.2022

PayPal doesn't work in russia, so only accept payment in crypto to my binance wallet. Don't buy here, i can't withdraw to paypal. Write to my mail davydoff2202@gmail.com 

i give you a wallet, or you can see wallet on the last photo here. Look at the steps here on photo how to pay on binance

You pay 20$ in crypto (no matter in  USDT or BTC), after which i will throw you stl files. Thank you!

************************************************************************************************************************************

I made you a list of good electronics, I've already lost over $1,000 on bad electronics. So you can say I saved you money. This table has what you need. 

I took a  new 180 kv 83100 alien motor. 

For this motor, you need to assemble an assembly of lifepo4 batteries so that there is no more than 75 volts, since this is the limit of the regulator and motor. It turns out: 20s lifepo4 (3.65 Vmax x 20s = 73 V)or use 18s or 16s , it's up to you. 

The remote and regulator are good, take only these! All other things like charging and wires are also good, take it if you don’t already have this. But it's all up to you, I don't know what you have. This is just a list of good electronics. In general, everything is up to you. I only advise.

New electronics that I can recommend

https://docs.google.com/spreadsheets/d/1RmLLy_ZbnNyPWFIGzeHl3TeCIs3ywHWsKKeYorZ-pXc/edit?usp=sharing

In this table you can view a list of parts ( Shaft, bearings, screws, nuts....) that will be needed for production

https://docs.google.com/spread...

*************************************************************************************************************************************

This is new Water Jet Drive 64 mm  for electric Surfboard:

https://www.youtube.com/watch?v=69YW7y_0W64

*************************************************************************************************************************************

My used electronics in video (do not use it):

- https://hobbyking.com/ru_ru/turnigy-rotomax-1-20-brushless-outrunner-motor.html

- https://hobbyking.com/ru_ru/hobbyking-yep-80a-hv-4-12s-brushless-speed-controller-opto.html

- https://hobbyking.com/ru_ru/turnigy-battery-5000mah-4s-25c-lipo-pack-xt-90.html (two batteries 4s x 2 = 8s)

I recommend using a 180-250  kv motor. Do not buy my rotomax 1.20, its 280 kv at 8s (8400 rpm) was not enough power and rpm.

**************************************************************************************************************************************

The model is very very durable, you can’t break it with your hands, I tried to compress it in different ways, but sintering is so good at pla that it is impossible.

This project was created in Fusion 360 and printed with my Artillery Sidewinder x1  

My print settings:

- Black PLA

- 220* nozzle;

- 60* bed;

- 65 mm/s

- 100% fill

*************************************************************************************************************************************

If you have questions, you can write to my mail:    davydoff2202@gmail.com

**************************************************************************************************************************************