Halloween Mask Pan&Tilt with a PIXY CMUcam5

So simple to build ... first I cut out the nostrils from the mask enough to fit the PIXY CMUcam5 lens through.  Then I did four little drops of Gorilla glue on the edges of the PIXY CMUcam5 to the mask.  Then I drilled a 10mm hole in the bottom of the mask chin to Gorilla glue a pin through to the "U" tilt bracket.  Then after assembling the Pan&Tilt it was easy to mount the face mask.  My next move is to find a thin plastic hollow skull about human size to fill in behind the mask, then I can give it draping black rags to hang down below and mount it on a short 1" PVC pipe for table top center piece, or any other length 1" PVC pipe to make it anything from 120cm to 240cm tall ghost.