Tape dispenser cutter 50mm - V2.5

Prints (0)

Description

Hello, after several projects, I found a compromise, which is valid for two uses. 

  It is possible to use the kit with or without cutter, depending on your needs.    It is possible to use the two supports at will, only one of the two or both coupled together.    The tolerances of the joints are 0.2mm 

The press was made in ABS, it is a while that I use it and I have not  seen signs of failure, if there were any problems I remain available.   

The project was designed for 50mm thick tape 

Design Files

File Size

Dispenser Nastro V2.5.stl
57.5 KB
Supporto1 V2.5.stl
91 KB
Cutter V2.5.stl
10.2 KB
Supporto2 V2.5.stl
42.9 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×