Replacement rubber feet for DJI Mavic PRO

Summary Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger legs there I needed a replacement. However, DJI doesn't make these available at this point in time outside of repair. So I eyeballed the dimensions as good as I could and printed these in Ninjatek Cheetah that I had around. Little bit softer compared to the originals but this filament is very tough. Print Settings Printer: Monoprice Ultimate Rafts: No Supports: Yes Resolution: 0.150 mm Infill: 100 Notes: Ninjatek Cheetah, 80C PEI Bed, 220C, Fan 40%, extrusion 0.9