Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Upgrade from my previous design (http://www.thingiverse.com/thing:1480871). This one holds two LED lamps for night flying.
25% infill is more than enough.
It was also designed to be printed with the holes in vertical position, in order to avoid easy breaking. It was meant for xiaomi yi, but it should work with any camera which has similiar design. Just strap the zip ties, install the LEDs and fly at night!
Holes are 4mm diameter, any zip tie up to this wide would secure the holder well to the drone.
LED holes are 12mm in diameter and 28mm deep, which will fit these lampshttp://www.banggood.com/2x-T10-Cree-Q5-Wedge-LED-Car-Reverse-Backup-Light-Bulb-7W-Pure-White-p-909647.html
40x40mm base
Comments