E3D Hotend Mount with z-probe mount and cooling fan for ORDbot H

SummaryThe layer cooling fan was designed for the ORDbot Hadron machine but could be used on any machine with a flat mounting plate. For the hinge pins use a section of 1.75mm filament.Print SettingsPrinter: ORD Bot HadronRafts: NoSupports: YesResolution: 0.2Infill: 50%Notes: designed for use with E3D hot end, LJ12A3-4-Z/BX Inductive Proximity Sensor. Hardware: 2x #6-32 Square Nuts. 2x #6-32 x 3/4" SHCS. Mounting: 2x M4 X 8 SHCS. For the layer cooling fan duct I just uses some two sided sticky tape and that works fine.