26mm Level 3 Menger sponge

This design is a slight modification of owens' support-free Menger sponge, with the base sliced off slightly to lie flat on the build platform. (Else a tiny corner sticks down in the center and prints on a tiny layer by itself, making the rest of the model too high off the build platform to be stable.) 

Used for a printer test of an Afinia H-Series printer with PLA, a MakerBot Mini, an Afinia H-Series printer with ABS, and a MakerBot Replicator 2, shown in that order in the figure above.

MakerHome, Day 357: http://makerhome.blogspot.com/...

=====

Twitter:  twitter.com/mathgrrl

Hacktastic blog:  www.mathgrrl.com/hacktastic

Shapeways geekhaus store:  www.shapeways.com/shops/mathgr... 

This design and all associated pictures and files are licensed under the Creative Commons Attribution Non-Commercial Share Alike license. If you want to use designs, images, or files outside of the terms of this license, please email [email protected].