Skull Book for dice or candy - Snap close, no magnets needed

A book that you can use to store your dice, markers, candy, etc. Blank cover without the skull included. Can store approximately six sets of polyhedral dice. See print settings below!

Height: 175mm / 7" Width: 125mm / 5" Thickness: 37mm / 1.5" Internal storage height: 30mm / 1.2"

I can adjust the size on request

Cover:

No supports needed

 0.2mm layer height 

2 walls 

10% infill 

To get a leathery look on the cover: Enable Fuzzy skin 

Fuzzy skin Point Distance 0.4mm 

Fuzzy skin Thickness 0.1mm (max) 

(Fuzzy settings are the same in most slicers but results may vary with printer model and outer wall print speed. Slower is better)

Pages: 

No supports needed

0.24mm layer height 

3 Walls 

10% infill