Designed by
Cisco_
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Summary RepRap, extruder with NEMA14 stepmotor. It's light and cheap to build. My actual step motor is 25mm deep (very small), and just print one job at 150m/s (Marlin_config 1881steps per unit mm) You need: 3 bearings 16x8x5 (Block/ filament gripper) 2 bearings 8x3x4 (middle gear) heat sink, if using very small motor, (mine start skipping at 65 C) and some nuts/bolts https://youtu.be/BVO7R3UbIoM Gear configuration copy from: Paste Extruder - 10 cc V2.1 - Extrudeuse a pâte by Shapescribe, published Dec 14, 2014 http://www.thingiverse.com/thing:591849
Design Files
File Size
idle.stl
778 KB
3gears.stl
7.99 MB
3gearsF.stl
7.99 MB
biggear.stl
916 KB
extr_braket2.stl
4.21 MB
poley2.stl
825 KB
Ydouble_gear_fixed_M4-encastre1a.stl
148 KB
Comments