Naglfar Viking Longship

Intended for 3D print.

This model pack contains 2 different longship hulls (on land or at sea), as well as masts, rudders and other vital parts to assemble full miniature ships. See detailed list below. The ships are based on the  mythological vessel Naglfar, its prow festooned with the toenails of dead giants.

The ships are intended for use in 28mm scale tabletop games, either as playable units or as scenery. They can also be used for purely decorative purposes outside of gaming, or even as floatable children's toys. The ships can be resized to suit both larger and smaller scales.

All model parts are prescaled to (roughly) 28mm scale. Some assembly is required. Which model part goes where should be fairly self-explanatory, and you can use the images provided on this page for guidance. Feel free to contact me if you have any questions regarding assembly.

Please note that the hull parts are large, and, depending on your printer size, may require cutting into two pieces before printing. I was able to fit the hull within a 14cm x 14cm x 14cm print area by placing it diagonally from top left to bottom right corner, but you will probably have difficulties fitting the hulls within areas smaller than that without resizing the hull. Cutting a hull across the middle -using any slicer software- and printing in two parts should be no trouble, but you can contact me if you need help cutting the model.

Detailed model part list

• 1 Naglfar on land
• 1 Naglfar at sea 
• 1 Mast with rolled up sail 
• 1 Mast with unfurled sail 
• 1 Rope (left and right side within the same .stl) 
• 1 Rudder 
• 1 Throne (purely optional, intended to be mounted at the back -sorry, aft- of the ship) 
• 1 Shield 
• 1 Oar 
• 1 Swords (Intended to lean on throne or elsewhere on ship. Purely optional. Ornate and plain variant within the same .stl)