Overwatch StandPhone

3D MODEL DESCRIPTION

Hi Makers, I present my new Overwatch themed standphone, decorate your gaming room with an appropriate standphone.

I’ll give you a couple of tips on the press, first of all the written print at 0.10 resolution and at a very low speed, so it is small, it will not waste much time, the stand always at 0.10 or maximum 0.15, at a speed higher than the writing.

Use simple PLA, or if you want more strength, PETG is very good, on temperatures, I can not give you general advice, because you will have to respect the temperatures of your supplier.

Use uniposca colors, to have a colored effect.

If you liked the design, leave a like and share it on your social media, I also thank you both if you buy it at the reasonable price of a coffee, but even just xke you stayed to admire my design.

"If you have any ideas, propose anything, I will try to achieve whatever you want, always relying on my abilities."

Thank you very much makers.

3D PRINTING SETTINGS

Layer 0.10 max 0.15 Infill 10/15% Top and Bottom Layer 4 Perimeter Layer 3 Support"View picture"