Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
The rod can be placed on any tripod or support.
It is used successfully on lakes and ponds. The device actually uses the same tensile strength of each element of the rod. It does not have many complex moving parts, so the efficiency is maximum!
Launch the fishing rod, then mount the device at a 90-degree angle: anchor the buckle to the ring stuck in the ground (or between the concrete slabs) and fix the nail of the device in the small ring of the last element of the fishing rod. DO NOT pass the fishing line under one of the two drums of the device now. Stretch the fishing line with the fishing reel, with the device fixed and mounted, and only then gently pass the fishing line under a drum of the device, easily, so as not to be triggered by mistake.
When the fish pulls, the device falls off the tip of the rod, and it returns to its original position.
ATTENTION: do not stay within the range of the fishing rod, so that it does not hit you when triggered !!!
NOTE: The wire that comes with the device can be replaced with a longer wire as needed!
ABS ,PETG,PLA...
Layer height = 0.16
Infill 30 %
Print speed = 50 mm/s
Add support
Comments