Strong Arm Hook - 3D Printed by Tj-K
717
Printer Used
My Rating
My Thoughts
Actually printed one a Anycubic i3 Mega S, but it’s somehow not listed on this site yet. Placing it fully upwards would make the strongest layering, but because of the pointy bottom there would be no bed adhesion, resulting in wobbling and failing. I tried with a raft as extra adhesion (see Cura Screenshot) but it still failed. At 45 degrees upward (like on the photo) you can support it well and the layering is sufficiently well. I printed 3 of them together and used Tree Supports which worked great. Two of these hooks now hold my 8,2 kg lawn mower. Even though it's "just a hook", I like the aesthetics of the design a lot. Thanks Dušan Fras!
Settings
Material Brand
Sunlu
Material Type
PLA
Material Rating
Layer Height
0.2
mm
Print Speed
60.0
mm/s
Extrusion Temperature
190.0
°C
Infill %
20.0
%
Supports
Yes
Comments