Skyrim: Dawnguard Vampire Lord - 3D Printed by dennis_mejillones
1757
Printer Used
My Rating
My Thoughts
This Thing was printed in PLA. It is composed of two models, the main bust and some small horns that are printed seperately. I have supplied some images with some colors that show you what to remove and where to add the horns. The red tinted is support structures to remove and the green are where the horns go. It was sliced with KisSlicer here are the settings: Skin Thickness: 0.6 loops:2 Extrusion Width: 0.4 Infill Extrusion Width: 0.4 Layer Thickness: 0.04 Temp: 1st layer-216, 2nd Layer-180 Fan on at all times and if possible a large fan cooling the whole part 50% infill Speed: Perimiter-20, Solid Infill-50, Sparse-70
Settings
Material Brand
ColorFab
Material Type
PLA
Layer Height
0.04
mm
Print Speed
20.0
mm/s
Extrusion Temperature
2nd Layer-180
°C
Infill %
50.0
%
Comments