iPhone 5/5s dock - 3D Printed by Lon McClure

Printed exceptionally well. Very well thought out design. I like it so much, I'll probably epoxy the charger cable in place. Update: I have hot-glued the charger cord in place and it works awesome! If you decide to do the same, put some saran wrap around the charger plug then plug it gently into your phone. Then apply some hot glue into the top of the stand. Immediately place the phone into position pushing the cable and plug into the hole. Let it sit a good 10 minutes to make certain the glue has completely set. Remove the phone and follow up with small amounts of hot glue to fill the hole from the top. Later, it's a good idea to apply more hot glue from the bottom into the cable hole and also to secure a loop of the cable to the inside with hot glue to provide strain relief. I also put a bead of hot glue (silicone will work here too) around the bottom ring to make it grippy so it doesn't slide easily. Great design! If you need an iPhone cradle, this one will be tough to beat!