Fox shock pump case - 3D Printed by Bisquick
892
Printer Used
My Rating
My Thoughts
Printed with skirt and supports at .6mm (e3d volcano) to height 23.5mm, then .2 layer height for the remainder. This is to minimize printing time and keep high resolution for the hinge holes to come out properly. I used a piece of 1.75mm filament as a hinge pin. Print took about 5 hours per side at 30mm/s Printing entire model at .2mm takes approx 8hours per side at 60mm.
Settings
Print Time
10
hr(s)
Material Brand
Argos
Material Type
PLA
Layer Height
0.6
mm
Print Speed
30.0
mm/s
Extrusion Temperature
205.0
°C
Infill %
20.0
%
Supports
Yes
Comments