Cat Phone Stand - 3D Printed by Duplicat
This Frisky cat needed a lot of special attention (they all do). In order to hold a Samsung GS5,,, I had to make a few modifications to the print. - Printed it on it's back, so I could maximize the height and width. - Had to take a soldering iron to his back, to flatten the layer lines. - Had to put a heat-gun to his skinny neck, to stretch it over, far enough to get around the phone. - Had to put the soldering iron on his little toes, to flatten them enough to hold the phone lower, and more stable. - Had to drill a hole in his foot, on the left side, and heat sink a 4"bolt in, in order to offset the weight of his big head. After torturing this Frisky fellow, it was time to dress him up, in a fresh warm coat of paint. Isn't he cute :)
Comments