![View dan steele's profile dan steele's avatar](http://assets.pinshape.com/uploads/user/avatar/11828/small_plasticdan2.png)
Recorder (Music instrument) - 3D Printed by dan steele
![Recorder (Music instrument) 3D Print 4447 Recorder (Music instrument) 3D Print 4447](http://assets.pinshape.com/uploads/print_image/file/4447/container_20151213_183536.jpg)
![Recorder (Music instrument) 3D Print 4446 Recorder (Music instrument) 3D Print 4446](http://assets.pinshape.com/uploads/print_image/file/4446/container_20151213_183728.jpg)
It was a lazy Sunday morning. Snow was falling, we wanted a recorder but didn't want to go out to buy one....so we printed it. Prints beautifully. Fit between pieces is very tight, I had to send two of the connections down a bit to make them fit, but that's a good thing, you wouldn't want it to be too loose and have air look out. It actually sounds very good, I imagine you could vary the tone slightly by using different materials (Nylon vs ABS vs PLA). I've printed dozens of spools of plastic over the last 4 years, from very simple to quite complex. This one is a must print. And as a side note this was my first every print with Taulman TGlass. It produces beautiful results, my only complaint is it's a bit brittle.
Comments