This is a stackable paint bottle holder for 2 oz paint bottles. It is based on the design by Jack Vlamings, though it is not a remix.   https://www.thingiverse.com/thing:3200860

Two versions are attached. The first has a low profile for paint bottles to be inserted from the top when unstacked. The second is designed for bottles to be slid in from the front. I made the taller one and like it a lot because I can pick it up with the nozzles down and the bottles don't fall out.

The shelf holds 7 - 2oz bottles of paint (4" tall bottles). Additional prints will stack on top of each other for convenient storage.

This was designed for printing on my Creality CR-10. I may someday put up shorter versions for smaller printers, especially if people ask for them.

Revisions:

7/24/20 - Made bottom holes deeper for better stability when stacked. Added wider base to posts for additional support.

Print Settings

Printer brand:  Creality

Printer:  CR-10

Rafts:  No

Supports:  No

Resolution:  Low Quality

Infill:  20%

Created Using Tinkercad