Racing car will be a good gift for your child. You can also print the wheel 4 times , the washer 8 times and the axles 2 times . Slide the axles into their holes and add the washers & the wheels; If the washers do not grip the axles, glue them to the axles or use some sticky tack to hold them in place.
Set the INFILL to 15 per cent . Add supports to the rear wing , air intakes , axles , axle holes and wheels .
If your slicer software can create tree-like supports, use these rather than linear supports. Carefully remove the supports especially under the wings , from axles and from their holes.
If you found this useful, please donate what you think it is worth to my paypal.me/lightshadowds
Loading prints...
Racing car TOY
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...