Probably the most iconic game prop in the entire Batman Arkham franchise, when I saw the official version I desperately wanted one but they were expensive and hard to find.
Sometime later I got around to modeling the trophy and printing one and this is what I came up with. It may not be the best way to build one but it's how I got it done.
It was designed to use stripped elwire that runs through channels in the question mark. Theres a compartment underneath to store electronics and pathway to route the cables from the compartment to the lamp holder. You can reference this short video I took a while back to see what I mean by stripping the elwire.
VIDEO: youtu.be/ahcQ8vJMmAA
RECOMMENDED MATERIALS:
El-Wire Green - amzn.to/3btooTQ
PLA Green - amzn.to/2JmqybM
PLA Silver - amzn.to/3dzTFq4
Raise 3D Printer - amzn.to/3aqoH1t
Soldering Kit - amzn.to/2UCexnU
Acrylic Paints - amzn.to/39mLNFc
Bob Smith Super Glue - https://amzn.to/3aqG5Dg
Recommend printing high infill and perimeters for the base maybe 30% infill so its heavy and less prone to knocking over.
NOTE: Some aesthetic and minor improvements were made to the design since some of the photos were taken nothing major.
Loading prints...
Riddler Trophy - Batman Arkham Asylum
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...