I recently changed to Klipper firmware to be able to easily add a second Ramps-Arduino for 12 volt temperature controlled fans. The space next to the printer was a mess so I decided to combine it all into a single enclosure. The current setup is ramps 1.6-mega on the left side and a ramps 1.4-mega on the right side. Raspberry pi is above the ramps 1.4. I also relocated the LCD adapter board to allow cooling for the raspberry pi. If there is interest I can add a case front for 2 ramps 1.6 or 2 ramps 1.4. If you have any questions, please ask. If you print it please post it.
Kevin
Loading prints...
3D Printer Electronics Enclosure
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Loading comments...