When I builded my printercabinet, I had a brainfart making of an spoolholder, what is attached on a rail and the rail is attached on the cabinets sidewall. Then the spoolholder could be moved from front to back ways if needed.
Rail: 280x41x10mm Rail holes: 3x4,5mm
SpoolHolder: 30x78,4/35x115mm Spool max. width: 90mm
31.1.2019 SpoolHolder with roller
Spool max. width: 84mm Bearings: 608 / d8mm / D22mm / B7mm x2
In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0,2mm
Infill:
10-20%
Filament: Real PLA / PETG
Notes:
Rail printed with 4 shells and 3 top/bottom. Holder 3 shells, 4 top/bottom.
In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.
Loading prints...
HJV SpoolHolder & Rail
Creative Commons Attribution-NonCommercial-ShareAlike
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution and under the same license.
Licensed under CC BY-NC-SA
Files Included
6 downloadable files:
Loading comments...