No Prints Yet
Be the first to upload a Print for this Design!
I made this to accommodate the cork-heater-glass setup I have on my printer. I'm using two sheets of 4mm cork, a sheet of 2mm glass, and the heater PCB (1.5mm) sandwiched between them. If you need to tighten its grip a little, a quick hit with a hair dryer makes it malleable enough to set where you need. I've also included the .blend for those who may want to alter it to suit their needs. Due to pinshape's system I was forced to give it a faux extension. Just remove the .txt and open it with blender