These Vases are printed using the “spiral outer contour mode” in Cura.
The red vase is printed 200% so it’s 506.5mm high. It is so big that the plastic became a bit to heavy and so it suffered a bit of warping. I used a 0.5mm nozzle for this one, but I wish I used a 0.8 mm. Print time was just under 24hours.
The gold PLA vase is 100% and thus 253.25mm high. This one printed fine.
Loading prints...
Experimental Vase
5
likes
2
collections
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Files Included
1 downloadable file:
Free download - login required
Downloaded: 160 times
Downloaded: 160 times
Loading comments...