This car stand is suited for 1/8 and 1/10 cars, it measure 160mmx100mm and only 25mm height when closed, about 75mm height when open. You need to print one top, one bottom and two links, the 0.5mm has a bigger clearance than the 0.3mm, print what it works the best for you (you need a snug fit so the stand doesn't wobble). I suggest to add rubber feets so the car doesn't slip too much. I used 3 perimeters, 3 top/bottom layers and about 15%-25% infill
Loading prints...
foldable RC car stand
4
likes
3
collections
Tags:
Creative Commons Attribution-NoDerivatives
You can download, share, and use commercially, but you cannot change the material in any way or use it to make something new.
Licensed under CC BY-ND
Loading comments...