No Prints Yet
Be the first to upload a Print for this Design!
Summary This is a pocket holster for the Smith and Wesson M&P Shield 9mm. I used a pocket clip from a cheap folding knife and a couple small neodymium magnets from a hobby store. I just glued the magnets into the two circular holes and screwed the pocket clip onto the other side. I did not add screw holes into the design, I just used a small drill bit instead. I wear this in my front right pocket with the front of the magazine facing forward. If you would like to wear it on the other side, the mirror or flip function in a slicer or tinkercad should work just fine. Print Settings Printer: Tevo Tornado Rafts: Doesn't Matter Supports: No Infill: 100% Notes: I printed this on its back, but it would probably work standing straight up as well.