Summary Using a CR-10 which has a larger build volume. You can now print the Rick Mask in as few as 4 pieces, 5 if you want a better mouth orientation. I print it at .2 res 20%infill I made this in a few days so please excuse the crappy finish (in photos). I started sanding/filling/finishing on Friday. Show was on Saturday. ;) I use screen door mesh for the eyes. Paint it white on one side. Makes it a lot easier to see through than the original eyes but are not as screen accurate. Use these eyes with magnets on both sides of the screen mesh. https://www.thingiverse.com/thing:2519198 Print Settings Printer: CR-10 Rafts: No Supports: Yes Resolution: .2 Infill: 20% Notes: I hate gluing pieces together so I meshed them together in Tinkercad so you can print larger pieces on your CR-10