Designed by
Peter Moore
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Summary This is a small sliding cupboard/door bolt. I have added slots in the main body to allow the bolt to be locked into the opened and closed positions. Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body. If the small pin is not printing properly, try laying it flat or maybe on a raft. As for print settings, 50-80% infill at least 2 shells (perimeters) If the body or receiver is too tight, try cleaning up with an 8mm drill run backwards. (be careful doing this, The sliding bar is deliberately flat on one side so it can be printed horizontally.
Design Files
File Size
Small_bolt_pin.stl
107 KB
Small_bolt_body.stl
377 KB
Small_bolt_receiver.stl
109 KB
small_bolt_bar.stl
290 KB
Comments