My character for the avatar contest. Typical rouge/fighter female game avatar; pretty but with inadequate protection in any place that counts. Figure stands 10cm tall. Uses roughly 20ml of resin with a print time of around 13 hours at 25 µm.
The model is designed to be printed on an SLA or DLP printer and is hollowed out to save on material. The model is broken up into into 2 parts, the figure and the base.
For the best orientation on the print bed it was necessary to put 2 small vent holes on the head of the character, these will need to be patched. There are also vent holes in the heels of the character but these are used to accommodate the pegs for the base. Here is a basic tutorial I recored for patching holes in SLA 3d prints. ( www.youtube.com/watch?v=R-Ey9B...)