No Prints Yet
Be the first to upload a Print for this Design!
This bike grip is relatively complex. Therefore it should be printed with double extruder and support of water soluble material. If you try to print it with only one extruder it will have a lot of support impossible to remove it. These pictures are the result of printing in Shapeways and just painted later with a normal car paint without need of polishing.
At home with a resolution of 0,1mm I could easily mount it, but the printing time is over 40 hours!
In order to assemble in the handlebar of your bike I recommend to use a screw (thread diameter 6mm and length over 40mm) and additionally a super glue. In some bikes the screw was enough, but in some bikes the glue was better.