Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Summary This Thing is a holder for the Ikea Produkt (Milk Frother). It prints with no rafts, no supports. .2mm layer height and 10% infill is fine. A couple pieces of 3M or your favorite VHB tape and you're all set. The stand-off spacing is necessary to protect the wisk end, as well as provide just a little flex to the model. There is also a small keyway for ensuring the switch remains turned off. Print Settings Printer: FLUX Delta Rafts: No Supports: No Resolution: .2mm Infill: 10% Notes: 3M/Foam Tape/VHB Tape
Comments