No Prints Yet
Be the first to upload a Print for this Design!
Summary This is a water bottle tote that attaches to your belt loop. It prints in two parts, attached using acetone (nail polish remover). I added a ring from a key ring and a simple carabiner clip. NOTE: Not all water bottles are created equally. I found that the bottles from Costco (Kirkland brand) are slightly larger at the base and do not slide in easily. The inner diameter of the tote is 67mm (~2.64 inches). You may want to scale the stl file up a percent or two to make it more universal. Print Settings Printer: FlashForge Creator Pro Rafts: No Supports: Yes Resolution: .20 Infill: 20-25% Notes: The base requires no supports. The top portion needs a support or two for the arch where the ring attaches. Print the two parts. Wipe the inside opening on the top portion with acetone, dip the top of the rod for the lower portion in acetone and press together. Wipe additional acetone on top of and below the two pieces and hold until set. Run ring through the hoop and connect the carabiner clip.