No Prints Yet
Be the first to upload a Print for this Design!
Summary Yet another base design of my water bottle tote. This one has stars in the base. It prints in two parts, attached using acetone (nail polish remover). I add a ring from a key ring and a simple carabiner clip. NOTE: Not all water bottles are created equally. I found that the bottles from Costco (Kirkland brand) are slightly larger at the base and do not slide in easily. The inner diameter of the tote is 67mm (~2.64 inches). You may want to scale the stl file up a percent or two to make it more universal. Print Settings Printer: FlashForge Creator Pro Rafts: No Supports: Doesn't Matter Resolution: .20 Infill: 20-25% Notes: Prints without supports. Top section loop prints a bit better if you do use a couple of supports but it is not necessary. Attach top and bottom by brushing both parts with acetone (nail polish remover). Brush a bit more on top and bottom of joints for added adhesion.